Sun Valley Built — First Production Run
All the tilt, no digging.
The Deck & Concrete Mount Tilt Base takes our Tilt-Up Base and bolts it flat to the surface you already have: a concrete footing, a deck, a patio, a rooftop pad. Same one-operator raise-and-lower. Same locked upright stop. No ground sleeve required.
Who this is for: the operator whose best antenna spot is not diggable — rooftop installs, existing slabs, engineered decks, rocky ground, and rentals where a poured sleeve is not an option. The Greyline vertical dipole already works on any surface a flag-rated pole can stand on; this base is how it stands there.
The Design, Plainly
- Welded steel anchor plate with four-bolt hold-down pattern — bolts to concrete or structural deck framing
- Gusseted upright carries the same tilt assembly as our Tilt-Up Base Kit
- 1/4" side plates, 3/8" Grade 5 pivot hardware on the tilt assembly
- Interfaces with the standard Greyline 2" OD x .125" wall base tube
- Adds 17" of height to your installation
- Built in our Sun Valley, Idaho shop
The 45-degree stop.
The antenna swings down one way only and stops dead upright — it cannot tilt over the top. Simple, mechanical, foolproof.
Fits: Greyline DXF and DXV antennas built on the standard 2" OD base tube. Larger-diameter base models: a larger receiver is in development — call before ordering: 435-200-4902.
Anchor hardware note.
Concrete anchors and deck fasteners are surface-specific and not included — call us and we will talk through your exact mounting surface before you order. 435-200-4902
First production run. Built in-house in small batches.
Ham Radio is fun again! Pass it on… 73