I purchase a 20’ Flagpole antenna that also included the 4’ extension. I installed the flagpole the end of January here at my home in central Florida. The install was easy with only a couple of small issues that were easily resolved by just thinking things through. I installed the antenna in the back yard in the HOA and have not had any complaints.
The performance of the antenna has been very good. The SWR on most band has been =< 1.5 except the 12 meter band. The SWR is just under 2.0. The DX into Europe and Africa has been good. Have done a lot of FT4 and FT8 with good reports. SSB has been good with good signal reports depending on propagation. All of my contacts have been made on 70 – 100 watts. I am using a SGC 230 tuner mounted at the base of the antenna
Most of my contacts have been 10 MHz – 28 MHZ. I have done some work on 40 meters but not much. Not much of an night owl so I don’t get very much of a change to use the antenna on 40 – 160 meters. The SWR is on these bands is 1.0 – 1.3, so I would expect good performance if I had more power.
At this point in time the only negative I have to report is the flag. It has been flying on most days in 5 to 15 MPH winds. I have taken it down when we had higher winds had exceed the 15 MHP. I noticed this morning the flag was torn and shredded. I took the flag down and noticed the flag was made by Anley and it was manufactured in China. I wouldn’t expect a flag to be in this condition after 3 months. I had USA made flags last over a year flying in much stronger winds that this one.
I'm only giving a 4 because of the flag issue. I will reach out to Greyline to see what they have to say.
